Sticky Back Tape, the original hook-and-loop fastener, features simple peel-and-stick application. It is perfect for office, school, home and workshop use. Use on smooth surfaces including walls, glass, tile, plastic, metal and wood. Tape works with other VELCRO Brand fasteners or adheres to itself.
Sticky Back Tape, the original hook-and-loop fastener, features simple peel-and-stick application. It is perfect for office, school, home and workshop use. Use on smooth surfaces including walls, glass, tile, plastic, metal and wood. Tape works with other VELCRO Brand fasteners or adheres to itself.
Peel tape from fastener and press firmly into place.
Adhesive reaches maximum strength after 24 hours.
Note: Not recommended for fabrics, flexible vinyl or outdoor use. Continued exposure to full sunlight can damage fastener.
Removal Instructions:
Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
Stick the ball on the adhesive which is on your substrate and pull it off
Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners
